Cisco 2702i lightweight ap factory reset when controller not available date.
Air cap2702i a k9 factory reset.
The 1040 1130 1140 1240 1250 and 1260 access points support the ieee 802 3af power standard cisco pre standard poe protocol and cisco intelligent power management for in line power sources.
1 i tried holding the mode button then provide power to the access point and continue to hold mode button until i see an amber.
Product highlights product type.
Cisco air cap1602i e k9 powerpc processor revision b0 with 98294k 32768k bytes of memory.
I want to factory reset a cisco air cap3702i a k9 access point but can t figure out the mode button sequence.
32k bytes of flash simulated non volatile configuration memory.
I m fairly certain this will work with most aironet access points but i only have this model available.
I have a problem configuring cisco air cap2702i f k9 ap 1.
I have followed the guide by cisco where it says hold the mode button while powering on which i believe has reset the ap.
I can not get into terminal via serial port 2.
Amazon partnerlink cisco konsolen kabel seriel.
But after connecting via serial cable it is still asking for username and password.
Connect to the access point with a serial console cable fire up putty and connect to the correct com port.
Note you can restore 1100 1140 1200 1240 and 1250 series access points to factory defaults by unplugging the power jack and plugging it back in while holding down the mode button for a few seconds or until the status led turns amber.
Access points can be powered from the 48 vdc power module or from an in line power source.
Wireless access point power source.
To factory reset a cisco air cap3502i e k9 follow the following.
Cisco air cap3502i e k9 aironet 3502i radio access point certified refurbished.
I want to do reset using hard reset but always fail do the steps in hard reset of cisco device are all the same can you give me the solution thanks.
J5 0 comments power on the ap while holding down the mode button until the led turns red then release.
1702i wireless transmission speed.
I am trying to reset a cisco aironet 2600 air cap2602i e k9.