Air Cap3502i A K9 Factory Reset

Aironet 2600i access point.

Air cap3502i a k9 factory reset.

I m fairly certain this will work with most aironet access points but i only have this model available. Connect to the access point with a serial console cable fire up putty and connect to the correct com port. Open the access point cover refer to the how to open the top cover section on page 2. 1 i tried holding the mode button then provide power to the access point and continue to hold mode button until i see an amber.

I want to do reset using hard reset but always fail do the steps in hard reset of cisco device are all the same can you give me the. We have had an issue with only one ap. The closest article link below. Resetting cisco air cap1702i e k9 capwap lwap access point to factory defaults and reconfiguration ap connect wlc.

In order to reset the access points to factory defaults please follow the steps mentioned below. I want to factory reset a cisco air cap3702i a k9 access point but can t figure out the mode button sequence. Resetting a air cap3502i a k9 this summer the it department at my location rolled out a little more than 100 air cap3502i a k9 s to much success. To reset the ap to it s default factory shipped configuration keep the mode button pressed for less than 20 seconds.

Air cap3502i a k9 configuration reset to factory default hello gentlemen i got the the old ap air cap3502i a k9 with old configuration i need to reset it to the default factory config. I have a problem configuring cisco air cap2702i f k9 ap 1. To factory reset a cisco air cap3502i e k9 follow the following. Air cap1702i e k9 please define a domain name first.

I can not get into terminal via serial port 2. The ap configuration files are cleared. In this post i will see how to do the same task using mode reset button of the access point. The are 4 dual band dipole and a smart antenna connector.

Follow these steps to delete the current configuration and return all access point settings to the factory defaults by using the mode button. But i couldn t find the manual how to do it using cli or gui.